Choose from the Americas (USD) or Global (GBP) websites to see content specific to your location and shop online.

FREE DELIVERY WITH EXPLORA CLUB / EU DUTIES INCLUDED

Westley Richards

+44 (0)121 333 1900

Group 3 Created with Sketch.
Request a brochure
Contact Us
Delivery & Returns
Your browser is out of date!

In order for us to provide you with the very best experience while visiting our websites, you must use an up-to-date browser.

Update my browser now

Blog Post Featured Image

A Westley Richards .375 Take Down Rifle.

Another one of our popular Take Down rifles is completed this week, this time in the classic .375 H&H Magnum. Here it is shown in the various stages of opening the package that arrives on your doorstep. First seen is the outer canvas cover with initials made to protect the lightweight leather case below. Both these items are made in house in our leather department. Open the case and the classic safari rifle is revealed, a big bang in a small compact package!

The outer canvas cover for a best leather case by Westley Richards.

Lightweight leather case by Westley Richards for Take Down rifle.

The inside of a Westley Richards  Take Down case

A Westley Richards .375 Take Down Rifle lies on its case.

375 Bolt Rifle-9058-Edit

5 Comments

  • vancedaigle on September 24, 2015 at 1:23 pm

    Good day Simon,

    What beauty Sir, after holding several if not many different maker's guns you really do have the gun that fits well. But most notable was that the Westley Richards I held were made to such a scale of Caliber. So many guns being built now are so much the same, whether it's a 300 are a 416 there guns feel so similar. Westley Richards guns are not a once you hold one you have held them all.... by any means. I guess the best word to describe your bolt actions would be Thoroughbreds!!
    Now to a question Sir, I always notice your rings on bolt actions as the engraving on the top is wonderful. What is the small metal shaft that goes from one ring to the other? I have not seen this before. Thanks for the time to address my question Sir.

    In Christ
    Vance,

    • Simon Clode on September 24, 2015 at 2:36 pm

      The mounts on this particular rifle are the H&H type. The bar which goes between the two sets of rings can be adjusted so that there is tension, as it were, into the bases where they lock in position. It is the method of getting the perfect fit for the mounts.

      Hope this makes sense, quite awkward to explain!

  • Larry on September 24, 2015 at 1:49 pm

    If I could only own one rifle, this would be it... Perhaps with an additional barrel in 300. What a wonderful rifle.. .And that wood is over the top.

  • Neill Clark on September 24, 2015 at 7:02 pm

    Simon, on earlier posts I have referred to "rifle porn", and what have you done? You've delivered a rifle Striptease, you should be ashamed! Seriously, it is a fine looking piece, the stuff of dreams and very impressive.

  • Peter Martisson on September 24, 2015 at 9:08 pm

    Simon

    I which I one day could say to you,make mine like that but please make it left handed.
    You never stop to amaze me with the sheer beauty of your rifles. Thanks for posting all this artistry in wood and steel and not to forget leather.

    Best regards
    Peter
    p's I hope that my English isn't to difficult to understand because it is a long time since I should have been studying it at school not day dreaming.

Leave a Reply

Your email address will not be published